- MPM54532
MPM54532
Session textval
Session Titefor popup
Description
The MPM54532 is a dual 6A power module that integrates a high-efficiency, step-down DC/DC converter IC, two inductors, and selected passive components into a single over-molded package.
The two outputs of the MPM54532 can be paralleled for up to 12A of current. The power module offers an active current balancing function that allows for equal current sharing between the outputs in parallel operation. The MPM54532 offers a dedicated, configurable low-dropout (LDO) regulator with up to 500mA of output current (IOUT) to provide an ultra-low noise output.
Constant-on-time (COT) control provides fast transient response and minimizes the required output capacitance.
The MPM54532 provides an on-chip non-volatile memory (NVM) to store and restore device configurations. Operation parameters, timing, and protection thresholds are fully configurable via the digital interface. The MPM54532 also features on-chip current and voltage sensing that allows for accurate input voltage (VIN), output voltage (VOUT), IOUT, and temperature telemetry via the digital interface.
The MPM54532 is available in an ultra-thin ECLGA (5mmx5.5mmx1.85mm) package.
-
Show more
Show less
Features & Benefits
- Wide 2.9V to 16V Input Voltage (VIN) Range
- 0.6V to 1.8V Output Voltage (VOUT) Range
- Max Output to VIN Ratio: 30%
- Dual 6A and Up to 12A for Parallel Operation
- High Efficiency at Light Loads in Parallel Operation with Phase-Shedding
- MODE Pin for Selection of VOUT, Parallel Mode, and Timing by Pin-Strapping
- Remote Sense for Both Output Channels
- Configurable 500mA-Rated Low-Dropout (LDO) Regulator with VIN Up to 3.6V
- Configurable Soft Start (SS), Soft Shutdown, and Delay with MPS's Patented FLEX-Timer Sequence Control
- Configurable Reference Voltage (VREF) and Slew Rate
- 500kHz, 750kHz, 1MHz, or 1.25MHz Configurable Switching Frequency (fSW)
- Accurate VOUT, Output Current (IOUT), and Junction Temperature (TJ) Telemetry
- Open-Drain Power Good (PG) Indication and General Status Interrupt
- Available in an Ultra-Thin ECLGA (5mmx5.5mmx1.85mm) Package
Active Part Numbers:
MPM54532GPB-0000-Z MPM54532GPB-0000-P MPM54532GPB-xxxx-Z MPM54532GPB-xxxx-P
Part numbers ending in P and Z are the same parts. P and Z only indicates reel size.
Meaning of P & Z
MPM54532 Resources
-
APPLICATION
OPTICAL NETWORK TERMINAL (ONT) UNITSAPPLICATIONAn optical network terminal (ONT) unit is a device that connects fiber optics cables to other wiring such as Ethernet and phone lines by converting the signal from optical to electrical and vice versa. Though they draw power from an electrical source, these devices also often have battery backup options in case of a power outage. It is typically part of a larger GPON (gigabyte passive optical netw...
-
APPLICATION
SMALL CELL BASE STATIONSAPPLICATIONSmall cell base stations are more useful than ever with the ubiquity of smartphones, rising data usage, and the advent of 5G. However, small cell base station designs must meet these demands as well as weight and volume restrictions, without sacrificing performance or significantly increasing power consumption. Todays wireless market demands reliability and flexibility wherever possible, so new pr...
-
PRODUCT CATEGORY
STEP-DOWNPRODUCT CATEGORY -
APPLICATION
OPTICAL MODULESAPPLICATIONOptical modules are optical transceivers used for high-speed data transmission, and are used anywhere larger amounts of data needs to be sent and received. From data centers to telecom, short or long range, optical modules are ideal for large, efficient data transfers. Optical modules can range in size and bandwidth, with the newest generation supporting up to 400GB/s. Due to the large amounts of ...
-
PRODUCT CATEGORY
STEP-DOWNPRODUCT CATEGORY -
PRODUCT
MPM3809PRODUCT2.3V to 5.5V Input, 0.6A, PSM Power Module in an Ultra-Small Package
-
PRODUCT
MPM3812CPRODUCT2.3V to 5.5V Input, 1A, Power Module in an Ultra-Small Package
-
PRODUCT
MPM3824PRODUCT2.75V to 6V, 2A, Ultra-Small, Ultra-Low Noise Power Module
-
PRODUCT
MPM3860PRODUCT7V 6A Step-Down Power Module
-
PRODUCT
MPM3650CPRODUCT1.2MHz, Synchronous, 2.75 to 17V, 6A, Ultra-Thin Power Module
-
PRODUCT
MPM3632SPRODUCTHigh-Frequency 18V/3A DC/DC Regulator with Integrated Inductor
-
PRODUCT
MPM3632CPRODUCT18V Input, 3A Module, Synchronous, Forced CCM, Step-Down Converter with Integrated Inductor
-
PRODUCT
MPM3822CPRODUCT2.75V-6V, 2A, Ultra-Small and Ultra-Low Noise Power Module
-
PRODUCT
MPM3811PRODUCT2.3V-5.5V Input, 1A Power Modulein Small 2mmx2mmx1.6mm QFN Package
-
PRODUCT
MPM3833CPRODUCT2.75 to 6V, 3A, Ultra-Small andUltra-Low Noise Power Module
-
PRODUCT
MPM3650PRODUCT1.2MHz, Synchronous, 2.75V to 17V, 6A, Ultra-Thin Power Module
-
PRODUCT
MPM3620APRODUCT24V Input, 2A Module Synchronous Step-down Converter with Integrated Inductor and PG pin
-
PRODUCT
MPM3830PRODUCT6V Input, 3A Module Synchronous Step-down Converter with Integrated Inductor
-
PRODUCT
MPM3510APRODUCT36V, 1.2A Module Synchronous Step-Down Converter with Integrated Inductor
-
PRODUCT
MPM3515PRODUCT1.5A, 36V, Synchronous Step-Down Power Module with Integrated Inductor and Power Good
-
PRODUCT
MPM3820PRODUCT6V Input, 2A Module Synchronous Step-down Converter with Integrated Inductor
-
PRODUCT
MPM3610PRODUCT21V Input, 1A Module Synchronous Step-down Converter with Integrated Inductor
-
PRODUCT
MPM3620PRODUCT24V Input, 2A Module Synchronous Step-down Converter with Integrated Inductor
-
PRODUCT
MPM3610APRODUCT21V Input, 1.2A Module Synchronous Step-down Converter with Integrated Inductor and PG pin
-
PRODUCT
MPM3506APRODUCT36V, 0.6A Module Synchronous Step-Down Converter with Integrated Inductor
Log in to your account
Create New Account