MPQ6653B-AEC1

MPQ6653B-AEC1

35V/1.2A, Single-Phase BLDC Motor Driver with Integrated Hall Sensor and MOSFETs, AEC-Q100 Qualified

Description

The MPQ6653B-AEC1 is a single-phase brushless DC (BLDC) motor driver with integrated power MOSFETs and an embedded Hall sensor. It drives a single-phase BLDC motor, with up to 1.2A of peak coil current. The wide input voltage (V_IN) range spans 3.5V to 35V.

Either the pulse-width modulation (PWM) signal or the DC voltage applied on the PWM pin can control the motor speed. The device features configurable soft commutation, a Hall offset angle, and speed curve configurations.

The FG/RD pin acts as either a rotating speed indicator (FG) based on the embedded Hall sensor’s output, or a locked-rotor indicator (RD) if locked-rotor protection is triggered.

Rich protections include input over-voltage protection (OVP), under-voltage lockout (UVLO), locked-rotor protection, over-current protection (OCP), and thermal shutdown protection.

The MPQ6653B-AEC1 is available in a TSOT23-6-SL package, and is available in AEC-Q100 Grade 1.

Features & Benefits

3.5V to 35V Operating Input Voltage (V_IN) Range
On-Chip Hall Sensor
Integrated High-Side MOSFET (HS-FET) and Low-Side MOSFET (LS-FET): 960mΩ
Selectable Open-Loop or Closed-Loop Speed
Configurable Curves
Configurable Starting Duty Cycle
Configurable Stopping Duty Cycle
Soft Commutation
Configurable Soft Acceleration Time
Configurable Hall Leading/Lag Angle
Supports 50Hz to 100kHz Pulse-Width Modulation (PWM) Input Frequency or DC Input
Automatic Reverse Current Block
24kHz PWM Output Frequency (f_PWM)
Configurable Current Limit
Short-Circuit Protection (SCP)
Over-Voltage Protection (OVP)
Standby Mode
Selectable FG or RD Output
Available in a TSOT23-6-SL Package
Available in AEC-Q100 Grade 1

Active Part Numbers:

MPQ6653BGJS-xxxx-AEC1-Z MPQ6653BGJS-xxxx-AEC1-P MPQ6653BGJS-0000-AEC1-Z MPQ6653BGJS-0000-AEC1-P

Meaning of P & Z

Related Products

MP6653B 35V/1.2A, Single-Phase BLDC Motor Driver with Integrated Hall Sensor and MOSFETs

The MP6653B is a single-phase, brushless DC (BLDC) motor driver with integrated power MOSFETs and an embedded Hall sensor. It drives a single-phase BLDC motor with up to 1.2A of peak coil current. The wide input voltage (V_IN) ranges from 3.5V to 35V.

The MP6653B controls the motor speed through the pulse-width modulation (PWM) signal or the DC voltage on the PWM pin. The device features soft commutation, a configurable Hall offset angle, and speed curve configurations.

The rotating speed indicator or locked-rotor indicator (the FG/RD pin) can act as a rotating speed indicator (FG) based on an embedded Hall sensor’s output, or locked-rotor indicator(RD) if locked-rotor protection is triggered.

Rich protections include input over-voltage protection (OVP), under-voltage lockout (UVLO), locked-rotor protection, over-current protection (OCP), and thermal shutdown protection.

The MP6653B is available in a TSOT23-6-SL package.