MP6612

MP6612

40V, 5A, H-Bridge DC Motor Driver with Current Sense and IN1 and IN2 Control

Datasheet

Description

The MP6612 is an H-bridge motor driver used for driving reversible motors, which can drive a DC motor, the winding of a stepper motor, or other loads. The H-bridge consists of four N-channel power MOSFETs and an internal charge pump to generate the required gate-drive voltages.

For the MP6612, control of the outputs is accomplished through the IN1 and IN2 pins. For the MP6612D, control of the outputs is accomplished through the DIR and ENBL pins. Otherwise, both parts are identical.

The MP6612 operates across a 4V to 40V motor power supply voltage, which can supply an output current (I_OUT) up to 5A according to the logic control. A very low standby quiescent current (I_Q) can be achieved when the device is disabled.

An internal current-sense (CS) circuit provides an output with a voltage proportional to the load current (I_LOAD). In addition, the MP6612 provides cycle-by-cycle current regulation and limiting. These features do not require the use of a low-ohmic shunt resistor.

Fault indication and internal shutdown functions are available for over-current protection (OCP), over-voltage protection (OVP), under-voltage lockout (UVLO), and over-temperature protection (OTP).

The MP6612 requires a minimal number of readily available, standard external components, and is available in a TSSOP-20EP package with an exposed thermal pad.

Features & Benefits

Wide 4V to 40V Operating Input Voltage (V_IN) Range
Internal Full H-Bridge Driver Supports 100% Duty Cycle with Internal Charge Pump
Current Sense: 10% Accuracy
Up to 5A of Continuous Driver Current
Low On Resistance (R_DS(ON)):
- 70mΩ High-Side MOSFET (HS-FET)
- 45mΩ Low-Side MOSFET (LS-FET)
Cycle-by-Cycle Current Regulation and Limiting
MP6612: IN1 and IN2 Logic Inputs
MP6612D: ENBL and DIR Logic Inputs
Low Quiescent Current (I_Q) Brake Mode with Two LS-FETs On
Configurable Current Limit
Fault Indication for Over-Current Protection (OCP), Over-Voltage Protection (OVP), and Over-Temperature Protection (OTP)
Available in a TSSOP-20EP Package

Active Part Numbers:

MP6612GF-Z MP6612GF-P

Meaning of P & Z

Related Products

EV6612-F-00A 40V, 5A, H-Bridge DC Motor Driver with Current Sense and IN1 and IN2 Control Evaluation Board

The EV6612-F-00A is an evaluation board designed to demonstrate the capabilities of the MP6612, an H-bridge motor driver used for driving reversible motors.

The MP6612 operates across a 4V to 40V input voltage (V_IN) range and can deliver a motor current up to 5A. The MP6612’s input control signals are applied through a connector on the board. For the MP6612, control of the outputs is accomplished through the IN1 and IN2 pins.

The MP6612 is available in a TSSOP-20EP package with an exposed thermal pad.

It is recommended to read the MP6612 datasheet prior to making any changes to the EV6612-F-00A.

$50.00
+ tax

MP6612DGF

40V, 5A, H-Bridge DC Motor Driver with Current Sense and DIR/ENBL Control