- Integrated BLDC Motor Drivers
22V, 1.2A, Three-Phase BLDC Motor Driver with Three Integrated Half-Bridges
You have a basic account.A myMPS+ account is needed.Upgrade to myMPS+
Session Titefor popup
The MP6543C is a three-phase brushless DC (BLDC) motor driver with three integrated half-bridges, consisting of six N-channel power MOSFETs, as well as six pre-drivers, two gate driver power supplies, and three current-sense amplifiers. Each half-bridge includes an enable (EN) input and pulse-width modulation (PWM) input. The MP6543C can achieve up to 1.2A of continuous output current (IOUT) across a 3V to 22V input voltage (VIN) range.
The internal current-sense circuit does not require a low-ohmic shunt resistor. Each half-bridge has an independent ground pin (LSSA, LSSB, and LSSC) that allows current to be measured via an external shunt resistor. This allows the MP6543C to be used for different application requirements.
An internal charge pump generates the gate driver supply voltage for the high-side MOSFETs (HS-FETs). A trickle-charge circuit maintains a sufficient gate driver voltage for 100% duty cycle operation.
Full protection features include configurable over-current protection (OCP), under-voltage lockout protection (UVLO), and thermal shutdown. The MP6543C is available in a QFN-24 (3mmx4mm) package with an exposed thermal pad.
- Show more Show less
Log in to your account
Create New Account
Features & Benefits
- 3V to 22V Operating Input Voltage (VIN) Range
- Three Integrated Half-Bridge Drivers
- 1.2A Continuous Output Current (IOUT)
- 110mΩ RDS(ON) per MOSFET
- Enable (EN) Input and Pulse-Width Modulation (PWM) Input
- 3.3V, 100mA Built-In Low-Dropout (LDO) Regulator
- Internal Charge Pump for 100% Duty Cycle
- Automatic Synchronous Rectification
- Integrated Bidirectional Current-Sense Amplifiers
- Configurable Over-Current Protection (OCP)
- Under-Voltage Lockout (UVLO) Protection
- Thermal Shutdown
- Available in a QFN-24 (3mmx4mm) Package
Active Part Numbers:
EV6543C-L-00A Evaluation Kit 3V to 22V, Three-Phase Brushless DC Motor Driver with 100mA LDO Regulator Evaluation Board
The EV6543C-L-00A is an evaluation board designed to demonstrate the capabilities of the MP6543C, a three-phase brushless DC (BLDC) motor driver. The MP6543C operates across a wide 3V to 22V input voltage (VIN) range.
The device integrates three half-bridges consisting of six N-channel power MOSFETs. Each half-bridge has an independent ground pin to provide current measurement via an external shunt resistor.
The rotor position information is provided by the Hall sensors assembled in the motor, and the driving control signals are generated by an external controller, such as an MCU or FPGA.
The MP6543C is available in a QFN-24 (3mmx4mm) package.