Semi-Shielded Inductors
Session textval
Session Titefor popup
The MPL-SE semi-shielded power inductors are shielded by an external magnetic epoxy resin for better magnetic characteristics. Their design offers a lower DCR and higher current capabilities.
Inductor Selector Tool
Shielded Optimized for MPS DC DC Content
-
REFERENCE DESIGN
VERSAL PREMIUM GEN2 (FULL POWER MANAGEMENT) - MPS SOLUTIONREFERENCE DESIGN -
REFERENCE DESIGN
VERSAL PREMIUM GEN2 (MINIMUM RAILS CONSOLIDATION) - HREFERENCE DESIGN -
REFERENCE DESIGN
VERSAL PREMIUM GEN2 (MINIMUM RAILS CONSOLIDATION) -M PS OVERDRIVE (0.88V)REFERENCE DESIGN -
REFERENCE DESIGN
VERSAL PREMIUM GEN2 (MINIMUM RAILS CONSOLIDATION) -MREFERENCE DESIGN -
REFERENCE DESIGN
VERSAL PREMIUM GEN2 (MINIMUM RAILS CONSOLIDATION) -L PS OVERDRIVE (0.88V)REFERENCE DESIGN -
REFERENCE DESIGN
VERSAL PREMIUM GEN2 (MINIMUM RAILS CONSOLIDATION) - L PS OVERDRIVE (0.8V)REFERENCE DESIGN -
REFERENCE DESIGN
VERSAL PREMIUM GEN2 (MINIMUM RAILS CONSOLIDATION) - LREFERENCE DESIGN -
ARTICLE
AN EQUATION-DRIVEN GUIDE TO DESIGNING A CRM/DCM BOOST PFCARTICLEDesigning compact and efficient power factor correction (PFC) stages for low-power to mid-power applications often requires operating in critical conduction mode (CrM) or discontinuous conduction mode (DCM). These modes offer improved efficiency and simplified control at light loads, but require careful design to ensure correct valley detection and mode transitions across the entire input range an...
-
VIDEO
WEBINAR - INSIDE AUTOMOTIVE DMS & OMSVIDEOExplore DMS/OMS fundamentals, focusing on typical system architecture, camera power architecture, and the use of MPS IR LED drivers to manage high peak currents and thermal performance in automotive imaging systems. The webinar also covers camera placement and the evolution of the smart cockpit. Key takeaways include: System & Power Architecture: Master the complete system and power architect...
-
ARTICLE
THE THEORY OF PARASITIC MILLER TURN-ON AND DRIVING TECHNIQUES FOR SIC MOSFETS AND CASCODESARTICLETo address the constant challenges that accompany increasing a power converter’s power density, switching frequency (fSW), and efficiency, it is vital that designers can switch power transistors quickly and safely. These needs have made wide-bandgap power semiconductors like silicon carbide (SiC) MOSFETs and cascodes more popular than silicon counterparts; however, these devices also work at much ...
-
ARTICLE
PRACTICAL DESIGN OF A MULTI-OUTPUT FLYBACK CONVERTER WITH IMPROVED CROSS-REGULATIONARTICLEA stacked-output topology, combined with a weighted feedback network, improves cross-regulation in multi-output flyback converters. This approach allows the main regulated output and the stacked auxiliary output to both contribute to the feedback loop, reducing the voltage deviation typically observed in semi-regulated flyback outputs. This article applies that methodology to a complete offline...
-
ARTICLE
DRIVING THE TOTEM-POLE CONVERTER'S SLOW LEG WITH RELIABILITYARTICLEWhether traditional or cutting-edge, most high-voltage power converter topologies are comprised of transistors placed either in half-bridge or full-bridge combinations. Typically, a bootstrap technique is used to drive the high-side transistor when a negative voltage is not required for the gate. While this technique seems simple and straightforward, special care must be taken when dealing with AC...
Log in to your account
Create New Account