EV3302-J-01A
You have a basic account.A myMPS+ account is needed.
Upgrade to myMPS+Product Description
The EV3302-J-01A is an evaluation board for the MP3302, a step-up converter designed for driving up to 27 white LEDs from a single cell lithium Ion battery. The EV board parameters are optimized for the load of 3 white LEDs in series, 9 strings paralleled.
The MP3302 uses current mode, fixed frequency architecture to regulate the LED current, which is measured through an external current sense resistor. Its low 195mV feedback voltage reduces power loss and improves efficiency. The MP3302 monitors the output voltage and turns off the converter if an over-voltage condition occurs due to an open circuit condition.
The MP3302 includes under-voltage lockout, current limiting and thermal overload protection preventing damage in the event of an output overload.
The MP3302 is available in small 5-pin TSOT23 package.
Product Features
- 3.3V to 6V Input Voltage Range
- Drives up to 27 White LEDs
- Up to 87% Efficiency
- Open Load Shutdown
- Fully Assembled and Tested
Parametrics
- IC Supported 1MP3302
2.5V-6Vin, 36Vout, 1.3A Boost WLED Driver
The MP3302 is a step-up converter designed for driving arrays of WLEDS from a single cell Lithium Ion battery. The MP3302 uses current mode, fixed frequency architecture to regulate the LED current, which is measured through an external current sense resistor. Its low 200mV feedback voltage reduces power loss and improves efficiency. The MP3302 is turned off if an over-voltage condition is present due to an open circuit condition. The MP3302 includes under-voltage lockout, current limiting and thermal overload protection preventing damage in the event of an output overload. The MP3302 is available in small 5-pin TSOT23 and 8-pin QFN (2mm x 3mm) packages.
Log in to your account
Create New Account