3V-18V, 1A-5A Programmable-Current-Limit Switch with Over-Voltage Clamp
The MP5010B is a protection device designed to protect circuitry on the output (source) from transients on the input (VCC). It also protects the input from undesired shorts and transients coming from the source. A small capacitor on the dv/dt pin controls the slew rate that limit the inrush current at the source. For instance, a 1nF capacitor results in a source ramp-up time of 3ms. The maximum load at the source is current limited using a sense FET topology. An external resistor between the I-Limit pin and the Source pins controls the magnitude of the current limit. An internal charge pump drives the gate of the power device, allowing the DMOS power FET to have a very low ON-resistance of just 40mO. The MP5010B also protects the source from the input being too low or too high. Under-voltage lockout ensures that the input remains above the minimum operating threshold before the power device turns on. If the input rises above the high output threshold, the MP5010B limits the source voltage.
- Wide 3V-to-18V Operating Input Range
- 5.7V Output Over-Voltage Clamp
- Integrated 40mO Power FET
- Enable/Fault Pin
- Adjustable Output Voltage Slew Rate
- Adjustable Current Limit
- Thermal Protection
- EnableActive High
- Fault FlagThermal Fault = Tri-State
- Ilimit (A)Prog.
- Slew Rate ControlYes
- Rds(on) (mΩ)40
- PackageQFN-10 (3x3)
- Iq (typ) (µA)860
- Iout (max) (A)5
- Vin (max) (V)18
- Vin (min) (V)3
Quality Policy, Certificates & Reliability Reports
All MPS parts are lead-free, halogen-free and adhere to the RoHS directive. See Environmental section for details.