2A, 35V, H-Bridge Motor Driver Evaluation Board
  • 個数 価格
  • 1
    $75.00 /単位


Arrives 3-4 business days.
Shipping only $5 per order.



The EV6516-F-00A is an evaluation board for the MP6516, an H-Bridge motor driver.

It operates from a supply voltage of up to 35V and can deliver motor current up to 2A. The input control signals for the MP6516 are applied through the connector on the board.


  • Wide 5.4V to 35V Input Voltage Range
  • Up to 2A Output Current
  • Internal Current Sense Output
  • 3.3 and 5V Compatible Logic Supply
  • Fault Indication Output


5.4V - 35V, 2.8A, H-Bridge Motor Driver in TSSOP16-EP

The MP6516 is an H-bridge motor driver that operates from a supply voltage up to 35V and delivers a motor current up to 2.8A. Typically, the MP6516 is used to drive a DC brush motor. For the MP6516, control of each half-bridge is independent, using IN1, IEN1, IN2, and EN2 pins.

An internal current-sensing circuit provides an output voltage proportional to the load current. The MP6516 also has cycle-by-cycle current regulation and limiting. These features do not require the use of a low-ohm shunt resistor.

Full protection features include over-current protection (OCP), input over-voltage protection (OVP), under-voltage lockout (UVLO), and thermal shutdown.

The MP6516 is available in a 16-pin TSSOP-EP (5.0mmx6.4mm) with an exposed thermal pad.