3V-5.5V, 1A-5A Current Limit Switch with Over-Voltage Clamp and Reverse Blocking
Session Titefor popup
The MP5017 is a protection device designed to protect circuitry on the output from transients from the input. Also, it protects the input from unwanted shorts and transients coming from the output.
During start-up, the inrush current is controlled by limiting the slew rate at the output. The slew rate is controlled with a small capacitor at DV/DT.
The maximum load at the output is current limited. The magnitude of the current limit is controlled by an external resistor from ILIMIT to GND. By controlling the gate voltages with a pair of N-channel MOSFETs, any current flowing from the output to the input is blocked.
Under-voltage lockout (UVLO) ensures that the input is above the minimum operating threshold before the power device is turned on. If the input voltage rises above 5.8V, the output voltage is limited quickly to 5.8V. SAS/OV is used to program the input over-voltage protection threshold.
is an open-drain output that reports a fail mode (low level) when any over-current, over-temperature, or output over-voltage is detected.
The MP5017 is available in a QFN-12 (2mmx3mm) package.
- もっと見る Show less
Log in to your account
- 3V to 5.5V Continuous Operating Input Range
- 16V Absolute Maximum Input Voltage
- Output Discharge
- SAS/OV Disable to Support DEVSLP or POWER_DOWN
- 5.8V Fast Output OVP Response
- Reverse Current Blocking
- Integrated 45mΩ RDS(ON) Power FET
- Adjustable Current-Limit through ILIMIT
- 210μA Low Quiescent Current
- Programmable Soft-Start Time through DV/DT
- Fast Response for Hard-Short Protection
- Fault Indication for Over-Current, Over-Temperature, and Output Over-Voltage
- OTP Auto-Retry with 76ms Recovery Delay
- Available in a QFN-12 (2mmx3mm) Package
EVHFC0500+MP6902/5017-00A Evaluation Kit 85VAC~265VAC/50Hz/60Hz, 5.3V/10A 4 USB Ports Evaluation Board
The EVHFC0500+MP6902+MP5017-00AEvaluation Board is mainly designed to demonstrate the capabilities of MPS flyback controller and secondary synchronous rectifier (SR) driver. The HFC0500 is a full-featured flyback controller aims at high-performance and high-integration solution while MP6902 is a secondary synchronous rectifier driver, which can promote converter efficiency observably. MP5017 is a current limiter to protect circuit.
The EVHFC0500+MP6902+MP5017-00A is typically designed for cell phone charger with 4 USB ports, each port has 2.4A source capability and input is from 85VAC to 265VAC, 50HZ/60HZ.
The EVHFC0500+MP6902+MP5017-00A has excellent efficiency, which can meet CoC V5 and DoE Level Ⅵ requirement easily. It meets IEC61000-4-5 surge immunity and EN55022 conducted EMI requirements. It has multi-protection function, e.g., Brown In/Out, over load protection, over voltage protection, short-circuit protection, cycle by cycle current limit and over-temperature protection, etc.