MP5016

MP5016

2.7 - 15V, 0.7 - 5A, Current Limit Switch with Over-Voltage Clamp and Reverse Blocking

Datasheet

Description

The MP5016 is a protection device designed to protect circuitry on the output from transients on the input. The MP5016 also protects the input from undesired shorts and transients coming from the output. During start-up, the inrush current is limited by limiting the slew rate at the output. The slew rate is controlled by the DV/DT pin setting and MODE pin setting. The maximum load at the output is current-limited. The magnitude of the current limit is controlled by an external resistor from ILIMIT to GND. There is a fixed 2.5A current limit when ILIMIT is floating. The output voltage is limited by the output over-voltage protection (OVP) function. The clamp voltage can be set by the MODE connection. The MP5016 offers a GATE drive signal connected to an external N-channel MOSFET gate to block current flowing from the output to the input when the IC is in enable off, power shutdown, or thermal shutdown. The MP5016 is available in a QFN-10 (1.5mmx2mm) package.

Features & Benefits

Wide 2.7V to 15V Operating Input Range
26V Absolute Maximum Transient Input Voltage
Selectable Over-Voltage Clamp Threshold
Fast Output Over-Voltage Protection (OVP) Response
Integrated 43mO Power MOSFET
Adjustable Current Limit or Fixed Current Limit when Floating ILIMIT
Reverse-Blocking MOSFET Driver
Soft-Start Time Programmable through DV/DT and MODE
Fast Response for Hard Short Protection
Over-Current Protection (OCP) Hiccup Protection
Thermal Shutdown and Auto-Retry
Available in a QFN-10 (1.5mmx2mm) Package

Active Part Numbers:

MP5016GQH-P MP5016GQH-Z

Meaning of P & Z

Evaluation Tools

EV5016-QH-00A Evaluation Kit 2.7V-15V, 0.7A-5A Current Limit Switch With Over Voltage Clamp and Reverse Block

The MP5016 is a protection device designed to protect circuitry on the output from transients on input. It also protects input from undesired shorts and transients coming from the output.

At startup, inrush current is limited by limiting the slew rate at the output. The slew rate is controlled by DV/DT pin setting and MODE pin setting.

The maximum load at the output is current limited. The magnitude of the current limit is controlled by an external resistor from ILIMIT to GND. There is a fixed 2.5A current limit when floating ILIMIT pin.

The output voltage is limited by output OVP function, the clamp voltage can be set by MODE pin connection.

The device is available in a QFN10 (1.5mm x 2mm) package.

$25.00
+ tax

EV5016-QH-00B

2.7V-15V, 0.7A-5A Current Limit Switch Evaluation Board With Over Voltage Clamp and Reverse Current Protection

Design Resources